Porcelain Mosaic Core White Polished Hexagon Backsplash Tile 3x3" - 3"x3" 

Porcelain tile is a durable and versatile material that can be used in a variety of settings. However, it is important to follow the proper installation tips to ensure a successful project.

Installation Steps:

1. Preparation:
   • Clean the Surface: Ensure the surface is free of dirt, dust, and grease. A clean surface guarantees better adhesion.
   • Level the Surface: Use a leveling compound to fix any uneven areas.
   • Dry Run: Lay out the tiles without adhesive to see how they fit and make any necessary cuts.


2. Planning the Layout:
   • Find the Center Point: Measure the area to find its center and start laying tiles from there. This helps in achieving a balanced look.
   • Dry Fit Tiles: Arrange tiles in your desired pattern, ensuring that the end tiles are not too small. Adjust as necessary to maintain a visually appealing layout.


3. Cutting the Tiles:
   • Tools: Use a wet saw, tile cutter, or snap cutter for clean, precise cuts.
   • Measure and Mark: Measure where the tile needs to be cut, mark it with a pencil, and cut slowly to avoid chipping.


4. Applying Adhesive:
   • Choose the Right Adhesive: Select an adhesive suitable for porcelain tiles.
   • Spread the Adhesive: Using a notched trowel, spread the adhesive on a small section of the floor. Hold the trowel at a 45-degree angle to create ridges.
   • Back Butter Tiles: Apply a thin layer of adhesive on the back of each tile for better adhesion.


5. Laying the Tiles:
   • Set the Tiles: Press the tiles into the adhesive firmly, giving them a slight twist to ensure good contact.
   • Use Spacers: Place spacers between the tiles to maintain even grout lines.
   • Check for Level: Use a spirit level to ensure tiles are even. Tap down any high spots and add adhesive under low spots.


6. Grouting:
   • Mix the Grout: Prepare the grout according to the manufacturer's instructions.
   • Apply the Grout: Spread the grout over the tiles using a rubber float. Hold the float at a 45-degree angle and work diagonally across the tiles to fill the joints.
   • Clean Excess Grout: Wipe away excess grout with a damp sponge. Rinse the sponge frequently to avoid smearing grout over the tiles.
   • Polish the Tiles: Once the grout has set, buff the tiles with a clean cloth to remove any haze.


7. Sealing The Grout:
   • Apply Grout Sealer: Once the grout has fully cured (usually 24-72 hours), apply a grout sealer to protect against stains and moisture.


8. Final Cleanup:
   • Final Wipe Down: After sealing, wipe down the entire surface with a damp cloth to remove any remaining dust or adhesive.

Additional Tips:

• Always read the manufacturer's instructions carefully before installing any type of tile.
• If you are not sure how to install tile, it is always best to hire a professional.
• Be sure to wear the proper safety equipment when installing tile.